Timing controller

Sequence controllers are mainly used in needle valve hot runner injection molding systems.

By detecting the clamping signal of the injection molding machine, according to the customer’s mold injection

Requires adjustable delayed clamping injection and different time periods to close the needle valve

and other actions to accurately open and close the needle of the pneumatic needle valve hot nozzle,

Eliminate or reduce the influence of joint lines on injection molded products. Note received

After the plastic signal, the gate is closed within the delay time T2, at

After the delay (DELAY) time T2 disappears, the gate opens (T1) and a

It remains on until the injection time signal ends.

Technical introduction:

 1. Operating ambient temperature: 0°C—-55°C 

 2. Time setting range: 0S—-999.9S 

 3. Control output form: 24VDC or 220VAC output) 

 4. Maximum output: AC220V/10A2200W 

 5. Input power: 200VAC —-240VAC, 50／60Hz

 6. Input signal: passive switch signal (mold closing signal or injection start signal)

 7. Compatible with all hot runner systems that meet industrial standards, and can directly replace other brands of products.

 8. Adopt integrated structure, small appearance, easy to place.

 9. Control time adjustment range: 0~999.9 seconds.

 10. It can directly control the relay on and off output manually.

 11. The input mode is passive switch signal (mold closing signal or injection start signal).

 12. Output relay switch contact: 10Amax./240V.

 13. Working power supply: 220VAC ±10%, 50/60Hz.

 14. Four red LED digital tubes for prompt information display.

 15. Independent output relay on, off, input signal and other status indicators.